Installation of injection mold transfer machine specifications, it is necessary to regulate the operation of the act. In order to ensure the transfer machine injection mold quality installation, the staff required to strictly enforce the following six specifications.
     1 pre-injection molds: injection molding machines installed in the mold before, should be tested in order to detect quality problems, the repair mode to avoid loading the machine and then removed when the mold template fixed template and mobile separate check, to pay attention to direction of the mark, so when the mold mistake.
     2. Bevel mode installation: put on when they should cooperate closely pay attention to safety, side parting agency if the injection mold, the slider should be installed in horizontal position, which is the active block and move around.
     3. Injection mold fastening: When positioning ring mold injection molding machine into position on the circle template given seat, the closed mold with a very slow speed, so that moving the template to mold gently pressed, then the pressure plate, clamping board must be installed gasket, the upper and lower clamping plates must be installed four, on the pressure plate, you must pay attention to the height adjustment screw adjusted to the same height with the foot mold, which pressure plate to be flat. If the pressure plate is inclined, and not be able to mold the mold foot pressure is very tight. Not near the pressure plate side of the mold, so as to avoid friction and damage the mold.
     4 more are out from top of mast: After fastening the mold, slowly start to die, until the template stops moving back, which is the location of ejector should be adjusted to the mold on the top of the board and still remain between the dynamic simulation backplane there are not less than 5 mm gap, to prevent damage to the mold, and can top out parts.
     5 clamping tightness adjustment: In order to prevent the overflow edge, and ensure proper exhaust chamber, in the regulation of hydraulic injection plug - when the toggle clamping mechanism, mainly with visual and experience that in the closed mold, the toggle slow down after that is not very natural, not Taimian Jiang to straighten, close the tightness of the mold just right. For the required mold temperature of the mold, mold temperature should be improved in the mold, then the school closed mold tightness.
6 connected to the cooling water: After the cooling water turned on, check whether the flow and leakage.
To learn more about the venue and http://www.zkmould.com  here.