In recent years, the rapid development of China's mould industry, but not adapt to the needs of national economic development! Why is this so? The main problem is the low excess mould, the mould is high demand, or even to be imported.  According to which mould as a typical representative of Huangyan, Huangyan Mould Factory abundance, but can do so but only a few high-grade mould. Of course, the mould industry throughout the country there are some problems, mould exports are still in a passive, at a disadvantage, mould needs restructuring to enhance international competitiveness.
  There five different foreign Mould
  Mould companies must find their own weaknesses, China's mould industry and the existence of five different foreign counterparts.
  1, the problem of raw materials
  Subject to price restrictions, made the mould for use more sophisticated 3Cr13 2Cr13 and heat treatment, and foreign materials are made of special mould DINI, 2316, its mechanical properties, wear resistance, corrosion resistance and brightness are much better than domestic polishing material. This fundamentally affects the quality and appearance of the domestic life of the mould.
  2, the level of manufacturing process
  China mould manufacturer, mixed conditions, the gap is large. Many manufacturers do not match the equipment, a lot of work depend on the manual completion of a serious impact on the accuracy and quality of the mould.
  3, mould design system
  While some domestic manufacturers are also using computer-aided design (CAD) and computer aided manufacturing (CAM), but still remain in the introduction, digestion and absorption stage, difficult to form a mature theoretical guidance and design systems. Therefore, standard mould design software system development is a priority.
  4, debug level
  By their very nature are mould tooling, production of qualified products is the ultimate goal. Therefore, mould quality, performance depends on the results of inspection and test mode. China Mould for short delivery time, test mode device limitations, often the quality inspection work on the user at the test mode, the user easily create a large number of losses and waste. And by the time the repair mode, site constraints, the optimal condition is often difficult to debug. And some more developed foreign companies have their own premises and equipment test mode, the user can simulate the working conditions of test mode, so in the shortest possible time frame to achieve good results.
  5, the support system
  Habits mould hard at manufacturing enterprises in China engaged in the production of scientific research, while ignoring the other equipment suppliers, raw material suppliers. Virtually allowing users to go a lot of detours. We must mould factory and other manufacturers and major research institutes to work together to create the best products for users and create greater profits, there is hope for themselves and create a broad space for development.
  Of course, this difference is only five o'clock in the mould manufacturers directly shown above differences, just some surface phenomena, of which there are more fundamental reasons, such as: mould factory cut-throat competition, customer requirements, etc.